Assembly Instructions

Secure the hooks into place using a screwdriver and screws.
Tape the bracket guide for the towel bar onto the bottom
half of the board with painter's tape. Pre-drill the holes
where indicated on the bracket guide.
STEP 9: Tape & Drill
Measure 9 inches down the back side of the board and
mark the location for the eyelet screws.
STEP 11: Mark for Eyelets
Pre-drill holes for the eyelet screws where marked in the
previous step. Screw the eyelets into place by hand.
STEP 12: Drill & Secure Eyelets
Screw the towel bar brackets into the board. Attach the
towel bar to the brackets.
STEP 10: Secure Towel Bar
STEP 8: Secure Hooks