Installation Instructions

Cut [4] 4-inch squares of laminate paper. Peel and stick
one piece of laminate paper to one side of an acrylic
square. Repeat on the remaining three acrylic squares.
STEP 3: apply laminate paper
Place an acrylic square over one of the printed letters, with
the laminate paper facing up. Center the letter underneath
the square. Trace the letter onto the laminate paper with a
pencil. Repeat this step for each acrylic square so that they
each have a letter traced to the laminate paper.
STEP 4: trace letters
Slowly peel the contact paper around the letter off
of the acrylic.
STEP 6: peel
Spray over the acrylic squares with the Frosted Glass Spray.
Allow to dry by following the manufacturer’s instructions.
Repeat this step on all four acrylic squares.
STEP 7: use frosted glass spray
Carefully cut out each letter from the laminate paper
using a hobby knife.
STEP 5: cut