Installation Instructions

Custom-made beverage coasters can be a fun and easy

project to give your living or dining room a personal touch.

Made with durable acrylic plastic that is easy to clean and

clear to match your home décor well. Choose letters that

are meaningful to you in a font that you nd stylish.

18” x 24” Clear

Acrylic Sheet

(433-4464)

Fine Point

Permanent Marker

(565-5201)

Safety Glasses

Rustoleum Frosted

Glass Spray

(557-8906)

8-Pack Clear

Bumpers

(234-0515)

Clamps

Hobby Knife

(243-8999)

Scissors

Clear Adhesive

Laminate Liner

(481-8025)

Gloves

Measure [4] 4-inch squares on a clear acrylic plastic

sheet. Clamp down the acrylic sheet in order to

carefully and slowly cut out each square using a jigsaw.

Remember to wear gloves and eye protection.

STEP 1: cut out acrylic squares

Choose which letters and what font you would like to have

featured on your coasters. Print them out on paper. Make

sure each letter is approximately 2 inches by 2 inches in

size. Make sure to print out the letters reversed so that they

appear correctly on the acrylic squares.

STEP 2: print out letters

SHOPPING LIST

Drill Jigsaw

PAGE 1
Custom-made beverage coasters can be a fun and easy project to give your living or dining room a personal touch. Made with durable acrylic plastic that is easy to clean and clear to match your home décor well. Choose letters that are meaningful to you in a font that you find stylish.
PAGE 2
STEP 3: apply laminate paper Cut [4] 4-inch squares of laminate paper. Peel and stick one piece of laminate paper to one side of an acrylic square. Repeat on the remaining three acrylic squares. STEP 4: trace letters Place an acrylic square over one of the printed letters, with the laminate paper facing up. Center the letter underneath the square. Trace the letter onto the laminate paper with a pencil. Repeat this step for each acrylic square so that they each have a letter traced to the laminate paper.
PAGE 3
STEP 8: peel off letters Peel off the laminate paper letters. STEP 9: attach bumpers On the same side of the acrylic square that you frosted, place a clear bumper in each corner. FOR MORE EASY HOW-TO PROJECTS, VISIT MENARDS.