Installation Instructions

Using the rest of the wood board, measure and mark
two 6” pieces to be used as the sides of the box.
Measure and mark one 5-3/8” long piece for the box
bottom and a 6-5/8” piece for the box front.
STEP 3: measure & Mark
Using a circular saw, cut out two 6” long pieces, a 5-3/8” piece,
and a 6-5/8” piece as measured and marked in the last step.
STEP 4: cut box pieces
Using the 3/32 drill bit, drill a pilot hole 1” from each
corner on the outer edge of picket centered between
the pencil mark and board end.
STEP 6: pre-drill
Attach the bottom piece of the box with two wood screws by
drilling them through the back of panel into the edge bottom piece.
STEP 7: secure bottom piece
Lay back panel at and position the 5-3/8” piece on top of the
back panel ush with bottom. Pick one of the 6” pieces next to
the side of the base board. Mark lines where the panels meet
with a pencil. Repeat this with the other 6” side piece.
STEP 5: mark sides before drilling