Installation Instructions

Get creative with the way you display your address, sure to

increase the curb appeal of your home. This modern

outdoor address sign features a small planter box to give

your front door an inviting appearance.

1 x 6 x 6’ Dog-Ear

Cedar Fence Picket

(173-1257)

Purdy® 2” Flat

Paint Brush

(561-0680)

Drill

(241-0480)

Assorted Address

Numbers

(216-2800-2809)

Drop Cloth

(561-2124)

3/32” Drill Bit

(252-9030)

1-1/4 inch Phillips

Deck Screws

(230-0274)

Safety Glasses

(212-3000)

Cabot® Gold

Sun-Drenched Oak Exterior

Stain 1 qt. (553-3315)

Circular Saw

(241-0430)

Beginning 1” from the top of the fence panel, layout the

address numbers to determine the length of the board.

Keep 2” between each of the numbers. Leave 11” below

the last number for the height of the box and ower.

STEP 1: lay out numbers

Measure 11” down from the bottom of the last number and

mark. Cut along mark with circular saw. This piece will be

the back panel.

STEP 2: cut

SHOPPING LIST

Phillips Drive Bit

(252-5216)

Tape Measure

(237-6540)

Pencil Gloves

PAGE 1
Get creative with the way you display your address, sure to increase the curb appeal of your home. This modern outdoor address sign features a small planter box to give your front door an inviting appearance. SHOPPING LIST 1 x 6 x 6’ Dog-Ear Cedar Fence Picket (173-1257) Assorted Address Numbers (216-2800-2809) 1-1/4 inch Phillips Deck Screws (230-0274) Cabot® Gold Sun-Drenched Oak Exterior Stain 1 qt.
PAGE 2
STEP 3: measure & Mark Using the rest of the wood board, measure and mark two 6” pieces to be used as the sides of the box. Measure and mark one 5-3/8” long piece for the box bottom and a 6-5/8” piece for the box front. STEP 4: cut box pieces Using a circular saw, cut out two 6” long pieces, a 5-3/8” piece, and a 6-5/8” piece as measured and marked in the last step. STEP 5: mark sides before drilling Lay back panel flat and position the 5-3/8” piece on top of the back panel flush with bottom.
PAGE 3
STEP 8: attach side & front panels With the pilot holes made in step 6, drill the side panels of the box on with four screws for each side. Position box front on top of shelf and hold in place. Mark lines where the panels meet with a pencil. Drill two pilot holes 1 inch from outer edge and between mark and board edge. Secure the front panel with four wood screws. STEP 9: stain Apply stain over all the wood pieces according to manufacturer’s instructions.