User manual

Technical Data
MEN Mikro Elektronik GmbH 4
20F302-00 E4 – 2010-12-16
Management Firmware Security Features
User authentication using 802.1x
Controlling management access through SNMP, CLI and web only from
authorized managers
MAC based access list (ACL) for traffic filtering
Rate-limiting and storm control to prevent packet flooding from malicious peers
Supported Ethernet Standards
Transparent bridging: IEEE 802.1D, 2004
VLAN: IEEE 802.1Q Rev D5.0, 2005
Port based VLANs: IEEE 802.1Q Rev D5.0, 2005
GVRP/GMRP support: IEEE 802.1D
Rapid Spanning Tree Protocol: IEEE 802.1D
Multiple Spanning Tree: IEEE 802.1s, IEEE 802.1Q Rev D5.0, 2005
IGMP snooping: draft-ietf-magma-snoop-12.txt
MLD snooping: draft-ietf-magma-snoop-12.txt
Link aggregation: IEEE 802.3ad, 2005
Port based authentification with EAP: IEEE 802.1X – REV2004
Link Layer Discovery Protocol: IEEE 802.1AB, 2005
Priority based switching: IEEE 802.1p
Service Interface
9-pin D-Sub connector at front
RS232 / V24
•I
2
C interface for external dongle
Front I/O
8 Ethernet ports via RJ45 or M12 D connectors
1 service interface via 9-pin D-Sub plug connector
16 link and activity Ethernet status LEDs (2 per channel)
Status LEDs for power, reset and error codes
CompactPCI® Bus
Compliance with CompactPCI® Specification 2.0 R3.0
Only one slot required on the 3U CompactPCI® bus
Peripheral slot
Compliance with PCI Specification 2.1
V(I/O): +3.3 V or +5 V
Ninth Fast Ethernet port via CompactPCI® J1
Electrical Specifications
Supply voltage:
- +3.3 V (-3%/+5%)
- +5 V (-3%/+5%)
Power consumption: 5 W (max.)
MTBF: Approx. 200,000 h @ 40°C according to IEC/TR 62380 (RDF 2000)