User guide

SC35 User Guide Ver 4.8 August 30, 2002 Page 6 of 25
3.2.2 SCSi Connector Pinout
The following shows the pin connections for the SCSI connector used on the
SC35.
PIN SIGNAL PIN SIGNAL
1 GROUND 2 DB0
3 GROUND 4 DB1
5 GROUND 6 DB2
7 GROUND 8 DB3
9 GROUND 10 DB4
11 GROUND 12 DB5
13 GROUND 14 DB6
15 GROUND 16 DB7
17 GROUND 18 DBP
19 GROUND 20 GROUND
21 GROUND 22 GROUND
23 RSVD 24 RSVD
25 GROUND 26 TERMPWR
27 RSVD 28 RSVD
29 GROUND 30 GROUND
31 GROUND 32 ATN
33 GROUND 34 GROUND
35 GROUND 36 BSY
37 GROUND 38 ACK
39 GROUND 40 RST
41 GROUND 42 MSG
43 GROUND 44 SEL
45 GROUND 46 C/D
47 GROUND 48 REQ
49 GROUND 50 I/O
3.3 SCSI Commands
3.3.1 Test Unit Ready Command – 00h
Test Unit Ready CDB
The TEST UNIT READY command provides a means to check if the logical unit
is ready. This is not a request for a self-test. If the logical unit would accept an