Owner`s manual

VG0969_B1 2/14/13 7
Installation Step 1
FOLLOW THE ASSEMBLY STEPS LISTED BELOW, PRIOR TO INSTALLATION OF THE UNIT. THE UNIT CAN BE
SUPPORTED BY EITHER THE SUPPORT BRACKETS (ITEMS 6, 12 & 25) OR BY THE FOUR LEVELING FEET
(ITEM 13). NOTE THAT THE SUPPORT BRACKETS MUST BE INSTALLED WITH EITHER SUPPORT
METHOD.
1. REMOVE THE THREE ASH/GREASE DRAWERS (ITEM 14) FROM THE UNIT.
2. FASTEN THE LEFT AND RIGHT SUPPORT BRACKETS (ITEMS 12 AND 25) TO THE UNIT USING THE TEN
1/4”-20 STAINLESS STEEL HEX BOLTS (ITEM 10).
3. FASTEN THE REAR SUPPORT BRACKET (ITEM 6) TO THE LEFT AND RIGHT SUPPORT BRACKETS (ITEMS
12 AND 25) WITH TWO 10-24 x ½” LONG STAINLESS STEEL SCREWS (ITEM 5) .
4. THIS STEP IS ONLY TO BE DONE IF THE GRILL IS GOING TO BE SUPPORTED BY THE FOUR
LEVELING FEET (ITEM 13) AND NOT THE SUPPORT BRACKETS (ITEMS 6, 12 & 25). THREAD THE
FOUR LEVELING FEET (ITEM 13) INTO THE BOTTOM OF THE UNIT.
5. TO REDUCE THE CLEARANCE TO COMBUSTIBLE MATERIALS, THE OPTIONAL HEAT SHIELD KIT
SHOULD BE USED. REFER TO PAGE ONE TO DETERMINE IF THE HEAT SHIELD KIT IS REQUIRED FOR
YOUR INSTALLATION. FOLLOW THE ASSEMBLY INSTRUCTIONS PROVIDED WITH THE HEAT SHIELD
KIT TO PROPERLY FASTEN THE KIT TO THE UNIT.
REFER TO PAGE 5 FOR ITEM PART NUMBERS, DESCRIPTIONS AND QUANTITIES