Owner`s manual

VG0969_B1 2/14/13 4
Unpacking and Assembling Your Memphis Wood Fire
Convection Grill.
*Grill requires (2) two people for safe assembly*
Please note that during shipping some movement may have taken place, so a complete visual
inspection is required. Be sure to inspect entire grill after removing the protective shipping carton.
Report any damage to your local dealer immediately. Shipping damage is not covered under warranty.
Some surfaces may be sharp so wear gloves when assembling. Do not plug in the grill until it's fully
assembled, the plastic protective film is removed from all stainless steel surfaces, and you're ready to
cook. See: “start up procedure” for more details.
Your carton will contain the following:
1– Pre-assembled grill head assembly
3– Large cooking grates
1– Small cooking grate
1- Integrated flavorizer / flame deflector, with removable hatch
1– Hardware bag
1– Right, left and rear mounting brackets (3 total)
1– Prewired Controller assembly
Tools Required
1/4” Socket Wrench
3/8” Open end wrench or socket
#2 Phillips head screw driver
Unpack and Identify Primary Components and Hardware (see “Hardware Kit”)
10- ¼-20 X 5/8” Bolts
2- #10 Self-tapping screws SS
4- #10 Self-tapping screws Black
1 - Power cord
1- Meat Probe
4- Built-In Leveling Feet
2– Controller Mounting Brackets
2– Concrete Anchor, 5/16” Pilot Hole
2- #10 SS PH. Screw, 1¾” Long
OPTIONAL Memphis Elite/Pro Built-In Heat Shield Kit
2- Heat Shields
4- #10 Self-tapping screws Black
Procedure for Installation/Assembly – See Diagrams on the following pages.