Owner`s manual

Memphis Select Owner’s Manual Revision D

Temp (Temperature) Display Screen

Displays temperature readouts, error messages, and power up readout:

LED Messages

1. HLnD, GrLL, v 7.02 These three screens will display when the appliance is plugged into a

surge-protected outlet. This describes the make and model of the board. (The 7.02 in this

example identifies the software revision – your grill may indicate a different version of

software.)

2. 350 F. This is the temperature that the grill is set at. Upon starting your grill, this temperature

will reflect what the grill was set at when it was last turned off. The temperature setting range

is from 200F to 500F while the actual temperature readout ranges from room temperature to

500F.

3. ER-1. This error code indicates the appliance has overheated.

4. ER-2. This error code indicates a failure to ignite. After pressing the ON touch pad, the

appliance must reach an operating temperature of 170F within 30 minutes. If it fails to reach

this temperature, the appliance will shut off and the error message will appear on the display

screen.

5. ER-3. This error code indicates a power failure causing the grill to cool.

Note: To reset an error, press on or off after correcting the problem

Temperature Display Screen

By pressing the display touch pad, the LED display screen will show either the actual temperature

within the appliance or the set-point. The LED besides actual or set-point is used to indicate which

temperature is presently displayed. Note: it is normal for the temp readout to vary from time to time.

This is caused by pellets being placed in the burn pot and the pellets burning down until the controller

calls for more pellets to be placed in to the burn pot. This works similar to an oven when it turns off

and on to maintain temperatures. As you preheat your grill, you will see larger deviations in

temperature. After the grill is preheated and the cooking temperature is set, the temperature will

stabilize within a normal range. UAn instant readout food temperature probe is highly recommended to

get accurate readings of your food.

Function Mode (Cook / Smoke) Touch Pad

By pressing the mode touch pad, the style of cooking and related pellet feed-rates will change. The

LED beside Cook or Smoke is used to indicate which mode is being used and blinks to indicate the

start up (igniter is on) or shut down (fans are running to cool the grill) status of the grill.