User`s guide

19
3. INSTALLATION AND SETUP
REMEMORIZER CONTENTS
If your REMEMOrizer was supplied by the designer, your REMEMOrizer should have been supplied
with :-
 The REMEMOrizer add-on card for your MTX
 Replacement OS and BASIC ROM chips (usage is optional)
 Replacement for PAL chip in MTX board position 6A
o GAL marked “2_32” for an MTX500 with 2 ROM chips (MTX500 only)
o GAL marked “3_32” for an MTX500 with 3 ROM chips (MTX500 only)
o GAL marked “2_64_S2” for an MTX512S2 only
 If you have an RS232 board, a replacement GAL marked “serial” for the RS232 PAL, (IC8)
 SD Card containing REMEMOrizer utilities and other MTX & CP/M software
SCHEMATIC DIAGRAM OF REMEMORIZER BOARD
ROMs Jumper
H = REMEMOrizer will provide replacement
ROMs.
(The existing ROMs must be removed from
the MTX main board)
L = Use existing MTX ROMs
MTX500 Jumper
H = Set if you have an MTX500 (32K RAM)
L = Set if you have 64K RAM
Please read through to the end of this chapter and understand it before connecting
REMEMOrizer to your MTX. Serious damage could occur to your MTX and/or REMEMOrizer if
you configure the jumper settings or ROMs incorrectly!
If you have any questions, STOP, and contact the designer for help before you begin.
Andy Key can be contacted by e-mail at [e-mail]