Datasheet

MemoRight NAND Flash-based Solid State Drive
MemoRight Confidential Page 20 3/6/2009
15-pin segment.
Table 14:SATA Connector Power segment Definitions
Pin Signal Name Signal Definitions
P1 V3.3 3.3V Power(Not used)
P2 V3.3 3.3V Power(Not used)
P3 V3.3 3.3V Power(Not used)
P4 Ground First Mate
P5 Ground Second Mate
P6 Ground Second Mate
P7 V5 5V Power, pre-charge, Second Mate
P8 V5 5V Power
P9 V5 5V Power
P10 Ground Second Mate
P11 Reserved Reserved
P12 Ground First Mate
P13 V12 12V Power(Not used)
P14 V12 12V Power(Not used)
P15 V12 12V Power(Not used)
5.2 Supported ATA commands
The following table lists ATA-standard commands supported by MemoRight SATA NSSD. For a
detailed description of the ATA commands, refer to the Draft ATA-7 Standard.
Table 15:Supported ATA commands
Command name Controller(in hex)
ATA-standard commands
Recalibrate
10h
Read Sectors
20h
Write Sectors
30h
Read Verify Sectors
40h
Seek
70h
Execute Device Diagnostic
90h
Initialize Device
Parameters
91h
S.M.A.R.T.
B0h
Read Multiple
C4h
Write Multiple
C5h
Set Multiple Mode
C6h
Read DMA
C8h
Write DMA
CAh
Read Buffer
E4h
Flush Cache
E7h
Write Buffer
E8h
Identify Device
ECh
Set Features
EFh
ATA-standard power-management commands
Check Power Mode
98h, E5h