Specifications

DEVICE MODE button (TV, VCR CBL or SAT) until the status indicator begins to blink (approx. 3
sec.).
2. Press an d release the POWER button tw ice. The status indicator will blink a con firmation (3 blink
s
that Master Power has been enabled.
3. Repeat the process to disable the Master Power feature.
NOTE: With Master Power enabled, the remote will send the power code plus 2 frames of repeat
code for each of the SAT, CBL, TV, and VCR, in that order. All of the devices should be within the
remote’s operating range so they can receive their power code.
OPERATING THE TEK PARTNER™
Normal Operation
Once you have set up the TEK PARTNER™ for your equ ip ment , it works like your original remo te
controls. To operate, just aim it at your equipment, press an appropria te Device Mode Button and
then command the desired function by pressing a corresponding button on th e T EK PARTNE R ™. Th
e
indicator turns on during signal transmission and as confirmation of button tou ch. At your button
touch, your TEK PARTNER™ illuminates the keypad for 5 seconds. You may see the keypad clearl y
even when you are operating your equipment in a dimly lit area.
CARE & MAINTENANCE
1. Do not expose your TEK PARTNER™ to d irect sunlight, high temperature, mechanical shock, or
liquids.
2. Do not use old and new batteries together as old batteries tend to leak.
3. Do not u se cor rosive or abrasive cleansers on y our TEK PARTNER ™ .
4.Keeptheunitdustfreebywipingitwithasoft,drycloth.
5. Do not disass emble your TEK PARTNER™, it contains no user-serviceable parts.
TROUBLE SHOOTING
Q. My TEK PARTNER™ does not work at all!
A. Check whether batteries are in good condition, inserted p roperly, and are in correct +/- polarity.
See INSTALLING THE BATTERIES.
A. Make sure you have pressed the Device Mode Button ( TV, VCR, CBL or SAT) before using any
functions.
Q. If several Device Codes are listed for my device, how can I select the correct Device Code?
A.ToseektheDeviceCodeforyourdevice,testthecodesonebyoneuntilthebuttonswork
properl y.
Q. My equipment re sponds only to som e o f the commands.
A. You ha ve set a c ode f or which only some commands work properly but some do not. Try other
codes until the buttons work properly. Make sure you have tried setup using DEV ICE CODES and
POWER SCAN (searching) instructions.
Q. My TEK PARTNER™ doesn’t control the Volume on my TV from CBL/SAT modes.
A. You need to set the VOLUME PUNCH THROUGH. See SETTING PUNCH-THROUGH section of this
manual.
SPECIFICATIONS
Operating System: Pre-programmed infrared remote control system.
Compatibility: Replaces most brands of infrared remote controls for TVs, VCRs, CBLs, and SATs
Power Requirement: 4 AA size batteries, alkaline recommended.
Dimensions: 5- 1/2"W x 8-1/2"L x 2-1/2"H
DEVICE CODE LIST
CODES FOR TV’s
AOC 005 0 19 0 20 141 151 221
Page 5 of 10Hytek Manufacturing
3/10/03htt
p
://www.h
y
tekmf
g
.com/manual2.html
Admiral 018 210
Akai 182 189 221
Amark 224 225
Amstrad 033
Anam 021 041 120 12 1
Anam National 211
Bell & Howell 018
CXC 041
Candle022025141213
Centurion 192 194
Citizen 022 023 024 025 026 141 202 213 224
Concerto 213
Contec 041 185 227
Corando 224
Coronado 225
Craig 041
Curtis Mathes 018 05 9 141 192 194 202 210 224
Daewoo005029030031032214215224
Daytron 192 194 224
Electrohome 189 224
Emerson 023 033 034 035 036 037 038 039 041 122 136 187 203 204 205 221 222 224 225 227
Envision 141
Fisher 042 216 217
Funai 041 187
General Electric 003 043 044 138 139 195 206 207 210 211 228
Goldstar 005 045 046 194 213 221 224 225
Grundig 047
Hitachi 048 049 050 051 052 053 054 055 130 185 213 224 225
Infinity 183
JBL 183
JC Penney 005 096 141 194 206 207 210 221 224
JVC 057 058 059 060 186
Jensen 05 6
KMC 224 225
KTV 041 221 224 225
Kawasho 061
Kloss 110
LXI 063 095 105 152 194
Lloytron 224
Lodgenet 0 18
Logik 018
Logix 018
Luxman 213
MGA 005 071 141 187 189 192 194 221
MTC 005 141 202 213
Magnavox 000 017 020 025 027 028 066 067 068 110 140 141 142 143 144
145 146 148 150 183 192 194 224 225
Majestic 018
Marantz 068 110 141 189 221
Memorex 018
Mitsubishi 004 005 070 071 072 123 187 189 192 194 221
NEC 005 006 007 131 141 191 192 194 213 221
National 011 1 83 190 195 196 211
Panasonic 008 009 011 012 183 195 196 211
Philco005025068110141183221224225
Philips 005 025 068 110 141 153 183 220 225
Pioneer 002 076
Portland 224 225
Proscan 210
Page 6 of 10Hytek Manufacturing
3/10/03htt
p
://www.h
y
tekmf
g
.com/manual2.html