Instruction manual

9
OPERATION
Insert the Universal Dock included
with your iPod (A) into the iPod
compartment (B) (as shown),
making sure the tabs are facing
front, and slip the tabs into place.
Press the rear side of the Universal
Dock until it is positioned inside the
iPod/iPhone compartment.
NOTE: If using the iPhone, locate
the correct Universal dock to use
as shown on page 15.
(A)
(B)
1
The iPod will charge as long as
this unit is connected with the
AC adapter.
Please see the next page for
instructions on using an iPod with
this unit.
3
Rotate the adjustable iPod support
knob counter-clockwise to raise or
clockwise to lower the support
position as desired.
Slide the iPod (A) into the
Universal Dock (B) (as shown).
Gently push down so the
connector on the iPod slides onto
the connector on this unit.
(A)
(B)
2
NOTES:
• When the iPod is connected to this unit, it
will be in the Pause mode. When the
iPod is removed, the unit will remain in
iPod mode.
• To remove the Dock, insert your finger
(or other object) into the gap in the Dock,
then gently pull the Dock out to remove it.
• CHARGING: When the iPod is inserted
into the dock and the AC adapter is
connected, whether this unit is on or off,
the iPod’s battery will charge until it is full.
• While there is an incoming call for the
iPhone, the music will pause. After
finishing the call, the music will resume
playing.
• If this unit is in iPod mode and is not
connected with the iPod/iPhone, the unit
will power off automatically after five
minutes. Press the Power button twice to
turn on the unit again.
INSERTING AN iPod/iPhone