Instruction manual

POWER SOURCES

AC CONNECTION

Insert the small end of the AC adapter

into the DC In jack (located on the rear

of the unit). Connect the other end to a

wall outlet having 120V AC, 60 Hz. The

AC indicator will appear in the display.

AC Adapter, DC 9V Z

NOTES:

• Remove both the DC plug and the AC-IN plug to disconnect the AC

adapter when not in use.

• Only use the supplied AC adapter which has the following specs:

DC 9V Z

CHARGING THE BUILT-IN LITHIUM BATTERIES

This unit has built-in Lithium batteries that will operate the unit when not

connected to the AC power source. When connected to AC (see above),

the built-in batteries will charge and the battery indicator will show the bars

cycling. When fully charged, all five bars in the battery indicator will be lit.

This battery cannot be replaced by the user.

NOTES:

• You must charge this unit for 12 hours before using for the first time.

• It takes about 7 hours to charge the batteries from empty to full.

• The backlight is 100% brightness in AC mode, but 50% brightness

while in DC mode only.

• Do not dispose of unit in fire; batteries may explode or leak.