Service manual

REMOTE CONTROL LAYOUT
- 4 -
METHOD OF RECALL V-BLOCK PASS NUMBER
If user forgets the V-Block Pass Number, call recall by the Service Remote Control or User
Remote Control.
1. If use the Service Remote Control, at the Pass Number entry menu, while holding down
[SHIFT] button and press the [Q.REV] button repeatedly four times.
2. If use the User Remote Control, at the Pass Number entry menu, while holding down
[VOLUME DOWN] button on the TV set and press number [3] button on the remote control
repeatedly four times.
3. The blinking “?” will be replaced with “!” after each press.
4. Release the [SHIFT] button or [VOLUME DOWN] button and then press [MENU] button. “V-
BLOCK SET” menu will be appearing on-screen with the user setting pass number.
VIDEOVIDEO