Specifications

Helpline No. UK
/
North Ireland 0870 727 0370 Rep. Ireland 1-800-992 508
Web Support www.medion.co.uk
Model Number: 30324
35
Code identification
Code identification gives you the opportunity to determine codes that have already been entered and stored in
the remote control. Proceed as follows:
Switch the relevant device on manually.
1. Keep the
CODE key pressed for approx. 3 seconds until the red LED remains solid.
2. Briefly press the required source key (
TV , SAT , AUX ).
3. Briefly press the
CODE button. The source key will briefly extinguish after the key has been pressed.
4. To find the first number, press the number keys from 0 to 9. If the source key extinguishes briefly, then it
is the first stored number.
5. To determine the second number, press the number keys again from 0 to 9. Repeat the procedure for the
third number.
6. The source key will extinguish as soon as the button for the third number has been pressed.
Code identification has now been completed.
Normal operation
Operating individual devices
After you have finished programming your remote control for your audio/video devices, the remote control will
work in the common main functions just like the original remote control of the respective device.
Point your remote control at the desired device and press the relevant source key. The key will light up briefly
but will not remain lit.
Activate the functions by pressing the corresponding function key of your universal remote control. The source
key will light up briefly each time the key is pressed.
Please note:
- In certain circumstances, not every function of your original remote control may be directly available on the
universal remote control.
- Especially for newer devices, it might be possible that the functions are stored to different keys than expected
or may not even be available at all.
“All off” function
You can switch off all pre-programmed devices at the same time. This is done as follows:
1. Briefly press the STANDBY key. The selected device switches off and the relevant source key will light up.
2. Immediately press the (STANDBY) key again and keep it pressed for 3 seconds. Now all pre-programmed
devices will be switched off consecutively. This takes about 3 seconds.
If a default device was switched off, it can be switched on via the “All off” function.
GUIDE - EPG – Electronic Programme Guide
The Guide (EPG - "Electronic Programme Guide") key has various functions depending on which code has
been used:
• For DVD codes the button opens the title menu.
• For SAT- or VCR codes you can use the button for programming, if your device has an EPG function.