Specifications

Helpline No. UK
/
North Ireland 0870 727 0370 Rep. Ireland 1-800-992 508
Web Support www.medion.co.uk
Model Number: 30324
33
The universal remote control
Scope of application
This universal remote control can operate the following types of devices:
• TV Television
• DVD DVD player MD 81777
• SAT, AUX Other devices (e. e. analogue satellite receivers, other DVD players, loudspeakers, tuners,
etc.). The label indicates the device type to be programmed. It is used to provide an easier
overview
Programming device codes
General information
For every device that you would like to operate using the universal remote control, you must program a four-
digit device code to a source key (TV, SAT, AUX). You can assign any key to any device (”flex mode”) with the
exception of the TV button, which can only be assigned one television.
Video recorder: Perform the code search when a video is in the machine.
Enter the device code according to the code list
The codes of the corresponding devices can be found in the Code List at the end of these operating
instructions. Proceed as follows:
1. Switch the relevant device on manually.
2. Keep the CODE key pressed for approx. 3 seconds until the red LED remains solid.
3. Briefly press the required souce key(TV, SAT, AUX).
4. Enter the four-digit code from the Code Table.
The key lighting will extinguish briefly each time the key is pressed.
If the entered code was valid, the light of the source key will extinguish after the last digit has been entered. If
an invalid code was entered, the red LED flashes for three seconds before extinguishing.
If the device does not respond as expected, repeat the programming, or try a different manufacturers code.
Select the code to which most of the remote control commands react correctly.
If this is also unsuccessful, the try one of the search methods described in the following sections.
Manual code search
Carry out a manual search as follows:
1. Switch the relevant device on manually.
2. Keep the
CODE key pressed for approx. 3 seconds until the red LED remains solid.
3. Briefly press the required source key (
TV , SAT , AUX ).
4. Keep pressing the (up to 350 times)
STANDBY or P/CH +– until the device that is to be controlled
switches off, changes channels, or responds accordingly.
5. The code search begins at the currently stored number.
6. Briefly press
OK to save the code.
Due to the considerable quantity of different code numbers, up to 350 different codes are pre-programmed per
device type. In individual cases it may be possible that only the most common main functions are available. The
process described here may not work for some special models.
11