Service manual

Body and Accessories Bumpers 8-25
2006 LSSV Service Manual Supplement
Bracket Replacement – Rear Bumper
(LSSV)
Removal Procedure
Caution: Refer to Vehicle Lifting Caution in Cautions and
Notices.
1. Raise and suitably support the vehicle. Refer to Lifting
and Jacking the Vehicle in General Information of the
2006 C/K Truck Service Manual.
2. Remove the rear D-ring (2) from the appropriate side.
Refer to Rear D-Ring Bracket Replacement (LSSV) in
Frame and Underbody.
3. Remove the bumper bolts (1).
4. Remove the bumper bracket to frame bolts.
5. Remove the bracket to bumper spacer from the vehicle.
Installation Procedure
1. Install the bumper bracket and spacer into position.
Notice: Refer to Fastener Notice in Cautions and Notices.
2. Install the bracket to frame bolts.
Tighten
• Tighten the side and upper bolts to 97 N•m (72 lb
ft).
• Tighten the lower bolt to 155 N•m (114 lb ft).