Service manual

8-22 Bumpers Body and Accessories
2006 LSSV Service Manual Supplement
3. Install the bolts (1) to the end cap brace. If the right side
is being installed the ground cable must also be installed.
Tighten
Tighten the bolts to 20 N•m (15 lb ft).
4. Install the blackout (B/O) marker lamp. Refer to Marker
Lamp Replacement – Front Blackout (B/O) (LSSV).
5. Install the brush guard end. Refer to Outer Radiator Grille
Brush Guard Replacement.
6. Install the center brush guard. Refer to Center Radiator
Grille Brush Guard Replacement.
Bracket Replacement – Front Bumper
Removal Procedure
1. Remove the center brush guard (2). Refer to Center
Radiator Grille Brush Guard Replacement.
2. Remove the end brush guard (1). Refer to Outer Radiator
Grille Brush Guard Replacement.
3. Remove the center bumper (4). Refer to Center Front
Bumper Replacement.
4. Remove the bumper end cap (3). Refer to Bumper End
Cap Replacement – Front.
5. Remove the front winch connector. Refer to Front Winch
Harness and Connector Replacement in Engine
Electrical.
6. Remove the front winch receiver. Refer to Front Pull
Winch Receiver Replacement in Frame and Underbody.
7. Remove the side frame bolts (1) from the inside and
outside frame.
8. Remove the lower frame washered bracket bolt (2) from
the frame.
9. Remove the bracket from the vehicle frame.