Service manual

8-20 Bumpers Body and Accessories
2006 LSSV Service Manual Supplement
Installation Procedure
1. Install the center brush guard end to the vehicle.
Notice: Refer to Fastener Notice in Cautions and Notices.
2. Install the bolts (1) retaining the brush guard to the
vehicle.
Tighten
Tighten the bolts to 20 N•m (15 lb ft).
3. Install the center brush guard. Refer to Center Radiator
Grille Brush Guard Replacement.
Center Front Bumper Replacement
Removal Procedure
1. Remove the D-Rings. Refer to Front D-Ring Bracket
Replacement in Frame and Underbody.
2. Remove the front winch power disconnect (if equipped).
Refer to Front Winch Harness and Connector
Replacement in Engine Electrical.
3. Remove the upper 4 bolts (1) from the bumper.
4. Remove the lower 4 bolts (2) from the bumper and
remove from vehicle.
Installation Procedure
1. Install the center bumper onto the frame brackets and
install upper bolts (1).
Notice: Refer to Fastener Notice in Cautions and Notices.
2. Install the lower bolts (2) and tighten all bolts.
Tighten
Tighten bumper bolts to 88-98 N•m (65-72 lb ft).
3. Remove the front winch power disconnect (if equipped).
Refer to Front Winch Harness and Connector
Replacement in Engine Electrical.
4. Install the D-Rings to the vehicle. Refer to Front D-Ring
Bracket Replacement in Frame and Underbody.