Service manual

8-14 Body Rear End Body and Accessories
2006 LSSV Service Manual Supplement
Installation Procedure
1. Slide the strap onto the top bows at the center.
2. Attach the retainer pin (1) assembly as shown at the
base of each bow end.
Notice: Refer to Fastener Notice in Cautions and Notices.
3. Attach the retainer cover strap assembly (2) to the holes
on both the left and right sides of the center top bow as
shown. Attach the straps to the inboard sides of each
with a nut.
Tighten
Tighten the 2 cover strap retaining nuts to 5 N•m (44 lb
in).
4. Slide the front roof bow onto the front struts and install
the pins into the bow/strut holes.
5. Slide the center roof bow on the center struts and install
the pins into the bow/strut holes.
6. Slide the rear roof bow onto the rear struts and install the
pins into the bow/strut holes.
7. Install the strap tensioners to the front and rear top bows
by threading them through the retainer loop of the side
rail.
Important: The buckle should face inboard.
8. Install the front of the cargo cover to the front end rail as
needed. Refer to Cargo Cover Replacement.
Cargo Cover Replacement
Removal Procedure
1. Pull apart the velcro corners of the front and rear flaps
and roll the cargo cover up over the top.
2. Remove the cargo cover from the side rail and end gate
retainers by releasing tension and removing hook. Pull
cover free.
3. Untie, release or unbuckle all cover retainers.
4. Remove the cargo cover.