MPD8819 User’s Guide Personal Compact Disc MP3 Player Before operating this product, please read these instructions completely.
SAFETY PRECAUTIONS CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. DANGEROUS VOLTAGE: The lightning flash with arrowhead symbol, within an equilateral triangle is intended to alert the user to the presence of uninsulated dangerous voltage within the product’s enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons.
SAFETY PRECAUTIONS (CONTINUED) INFORMATION: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
Dear Customer: Selecting fine audio equipment such as the unit you’ve just purchased is only the start of your musical enjoyment. Now it’s time to consider how you can maximize the fun and excitement your equipment offers. This manufacturer and the Electronic Industries Association’s Consumer Electronics Group want you to get the most out of your equipment by playing it at a safe level.
LOCATION OF CONTROLS 1 11 12 1. 2. 3. 4. 5. 6. 7. 2 3 4 5 13 6 7 14 LINE OUT Jack (Side of Unit) PROG/EQ/ENTER Button Skip (o)/Ã Button Skip (n)/¨ Button Display ESP/MENU Button DC 4.5V Jack (Rear of Unit) 8 9 10 15 9. STOP (■)/POWER OFF/▼ Button 10. MODE/CLEAR Button 11. PHONES Jack (Side of Unit) 12. VOLUME Buttons (Side of Unit) 13. CD Compartment 14. CD Door OPEN Switch 15. Battery Compartment (Bottom of Unit) Z 8.
POWER SOURCES This CD player requires either two (2) “AA” batteries (not included) or an AC adapter (not included). BATTERY INSTALLATION “Low Battery” will light in the display when – –+ batteries are low (when using battery power). 1. Open the battery compartment door on the bottom of the unit by sliding it out and then lifting it. To prevent the possibility of losing the cover, it cannot be removed. – 2.
CD OPERATION ADJUSTING THE VOLUME TURNING POWER ON/OFF 1 1 1 2 You can adjust the digital volume level from Minimum "MIN" to Maximum "MAX" by pressing the VOLUME UP/DOWN buttons. Press the PLAY/PAUSE (®p)/POWER ON/▲ button 1 to turn the unit on. To turn the unit off, press the STOP (■)/POWER OFF/▼ button 2. The unit will automatically shut off if stopped (CD Standby) for one minute. 1 NOTE: If there is no disc in the CD compartment or the CD door is open, you cannot adjust the volume.
CD OPERATION (CONTINUED) TO INSERT AND PLAY A CD This CD player is designed to play all kinds of audio discs and MP3 CD Roms, such as CD recordables and rewritables. Do not try to play CDI, CDV, DVD or computer CDs in this unit. 1 2 2 1 Press the PLAY/PAUSE (®p)/POWER ON/ ▲ button 1 to turn the unit on. 1 the CD Open the CD door by sliding Door OPEN switch 2. Gently press a disc, label side up, onto the spindle until it locks in place. Close the CD door.
CD OPERATION (CONTINUED) CD PLAYBACK NOTES: • See page 15 for more information on MP3’s. • When recording (“burning”) CDs, make sure the session is “finalized”, or simply record (“burn”) only one session. You can find more information in your recorder’s manual. • This unit is capable of playing standard CDs or 3” singles; no adapter is required. • If a disc is inserted incorrectly, dirty, damaged or not present at all, “no disc” will appear in the display.
CD OPERATION (CONTINUED) TO BEGIN PLAYBACK FROM A SPECIFIC TRACK 2 1 1 2 2 When the desired track number (and file number if using MP3) appears in the display, press the PLAY/PAUSE (®p)/POWER ON/▲ button. Playback will begin with the track (or file) you selected. 1 2 After you insert the disc into the CD player and the total number of tracks appear on the display, you may press either the Skip o 1 or n 2 button to select a specific track for playback.
CD OPERATION (CONTINUED) HIGH-SPEED MUSIC SEARCH 1 During playback, depress and hold either the Skip o 1 or n 2 button to move the player forward or backward within a track to locate a specific musical passage. The player will move forward or backward at high speed as long as the buttons are depressed. When you release the Skip o 1 or n 2 button, normal playback will resume.
CD OPERATION (CONTINUED) REPEAT PLAYBACK OF ALL TRACKS 2 1 1 2 To repeat all the tracks on the CD, while in the Stop mode, press the MODE/CLEAR button twice; “REP A” will appear in the display. 2 1 REPEAT PLAYBACK OF A FOLDER (MP3 w/folders only) 2 2 2 3 Press the PLAY/PAUSE (®p)/POWER ON/▲ button 1 to begin playback. (For MP3 CDs, the “REP A” indicator will disappear after a few seconds.) All tracks on the disc will be repeated continuously.
CD OPERATION (CONTINUED) INTRO PLAYBACK (Will play the first 10 seconds of each track) 2 1 1 2 While in the Stop mode, press the MODE/CLEAR button 3 times (4 times if an MP3 CD with multiple directories is inserted); “INT” will appear in the display. 1 2 2 2 3 Press the PLAY/PAUSE (®p)/POWER ON/▲ button 1 to begin Intro playback. (For MP3 CDs, the “INT” indicator will disappear after a few seconds.) The first 10 seconds of all tracks on the disc will be played in sequence.
CD OPERATION (CONTINUED) TO PROGRAM THE MEMORY (UP TO 24 TRACKS) Programming is the ability to preselect the order in which a series of tracks will be played. 2 1 1 2 While in the Stop mode, press the PROG/EQ/ENTER button. The track number will blink and “P-01” will appear in the display. 1 2 4 1 2 3 Select a track to be programmed using the Skip o 1 or n 2 button. If using a MP3 disc, see note below. Press the PROG/EQ/ENTER button to memorize the track.
CD OPERATION (CONTINUED) NOTES ON PROGRAM PLAYBACK • You can review the program by pressing the PROG/EQ/ENTER button repeatedly while in the Stop mode. • To add a track to the program memory, simply press the PROG/EQ/ ENTER button repeatedly until the track (directory for MP3) appears and “00” blinks in the display. Then follow steps 2 and 3 on the previous page. • Press the STOP (■)/POWER OFF /▼ button to stop the program before it is finished (the program memory will be kept).
CD OPERATION (CONTINUED) MP3 FAQs–Frequently Asked Questions Please read before playing an MP3 CD. Does the unit support packet write CD-RW? Yes, it can. You can add or delete MP3 files without reformatting. It appears like a PC hard drive. Can the unit read regular music CDs? Yes, it can. However, you can not mix MP3s and WAV files on the same CD. If you do this your Portable MP3 CD Player will play only the MP3 files.
CD OPERATION (CONTINUED) SELECTING SONGS BY MP3 TITLE You can search for a song by title as follows: 2 1 4 3 1 2 Press the MENU/ESP button; the alphabet will appear in the display. 3 3 2 1 2 2 3 Select the first letter of a file you would like to listen to using the Skip o/Ã 1 and/or n /¨ 2 buttons. Press the STOP (■)/POWER OFF/▼ button 3 to access the lower letters or the PLAY/PAUSE (®p)/POWER ON/▲ button 4 to access the higher letters.
CD OPERATION (CONTINUED) SEARCHING THROUGH MP3 DIRECTORIES You can search the contents of the directories (if burned on CD) as follows: 2 1 1 2 Press the MENU/ESP button twice; the first directory will appear in the display, as well as its contents. To select a file from the directory, use the Skip o/Ã 1 and/or n/¨ 2 buttons. 3 4 1 2 If you would like to change directories, use the PLAY/PAUSE (®p)/POWER ON/▲ 1 and/or STOP (■)/POWER OFF/▼ 2 buttons.
CD OPERATION (CONTINUED) SINGLE SESSION The chart below is an example of a Windows Explorer display that will appear on your computer monitor for a single session MP3 CD Rom with directories/albums. Check the added notes to help you understand the MP3 CD unit display and the playback sequence of directories/albums and tracks on a single session MP3 CD. MULTI SESSION The computer user does not need to finalize the CDR disc as music is burned on the CD.
CARE AND MAINTENANCE Caring for Compact Discs • Treat the compact disc carefully. Handle the compact disc only by its edges. Never allow your fingers to come in contact with the shiny, unprinted side of the compact disc. • Do not attach adhesive tape, stickers, etc. to the compact disc label. • Clean the compact disc periodically with a soft, lint-free, dry cloth. Never use detergents or abrasive cleaners to clean the compact disc. If necessary, use a CD cleaning kit.
TROUBLESHOOTING GUIDE If you experience a problem with this unit, check the chart below before calling for service. SYMPTOM Unit will not turn on. Disc will not play. Erratic CD playback. No sound from headphones. ESP not working. CAUSE Dead batteries, or not installed properly. Weak or dead Rechargeable batteries. AC adapter not connected. CD compartment not closed. Disc inserted incorrectly. Dirty or defective disc. Moisture condensation on disc. Dirty or defective disc.
SPECIFICATIONS Power Requirement DC ............................2 x AA (LR6) Alkaline batteries Power Requirement AC...................DC IN 4.5V Adapter (center positive) Output Level (Line Out) ............................................0.6VMS (47K Ohms) Output Level (Headphones) ..........................................16mW (32 Ohms) MPEG Rate ............................................................................32-384Kbps Sampling Frequency ..................................8/11.
Memcorp, Inc. Weston, FL Printed in Hong Kong Visit our website at www.memorexelectronics.
