Owner`s manual

8
9 RECORDED FILE PLAY
10 AUDIO VOLUME CONTROL
• To play the recorded fi les, the play mode should be set to VOICE.
• In the standby state, press the PLAY/PAUSE button briefl y to play.
Press again to pause, and then press again to continue to play.
• Push the jog buttons briefl y in the directions of either previous ( )
or next ( )to go to previous fi le or next fi le in the selected folder accordingly.
• Push the jog buttons for more than 2 seconds in the directions of either previous ( ) or next ( )
while playing, then fast search is initiated.
• For over volume level 11, it is reset to volume level 10 on the next power on.
(This is the hearing protection feature from the high audio volume of the earphone.)
• Push the jog buttons briefl y in the directions of either higher
volume(+) or lower volume(-), then the LCD panel displays audio
volume level and the audio volume is controlled accordingly.
• If the volume is set to over level 11 and the power is off and on,
it is reset to volume level 10 for hearing protection from the loud
audio volume damage.
12 REMAINING RECORDING TIME CHECK
• In the standby mode, push the jog button long enough ( for more than 2 seconds) in the direction of
volume(-), then it display the remaining recording time. The time differs depending on the audio
recording quality.
-.The time is automatically calculated according to the recording auto quality mode (PCM, HQ, SP, LP).
If the remaining time is over 10 hours, the “MINUTEs” and “SECONDs” are not displayed and only
“HOURs” is displayed. The display method is “TIME H”.
< Remaining recording time
less than 10 hours >
< Remaining recording time
over 10 hours >
hour hour
min
sec
11 RECORDED TIME CHECK
• In the standby mode, press the MODE button briefl y to display the recorded
time of the selected fi le. There may be 1 or 2 seconds difference in
the actual time length depending on the fi les.
< Recorded time length display >
< Minimum
audio volume >
< Maximum
audio volume >
< VOICE display >
V V
V V
V V
V V