Operating instructions
Installation Optimum control and thermal conditions can only be ensured
options
if
the unit is hung or positioned accurately horizontally
(use spirit level
if
necessary).
If
using
a
stand
(accessory for models 500
to
700
f
fig. c) or if
having
model 800, then ensure that the floor is level. Ensure
at
least 150 inn (series UE/ULE) resp. 80
mm
(series BE) clear-
ance between back
of
oven and
wall.
The distance between
ceiling and oven should not
be
less than 200 nrm. After the
cabinet has been set horizontally the door can be adjusted
if required (see Service
Instructions).
Model 800 is movable. The front castors are lockable
by
means
of a
fixation. In order to grant the stability
the
front castors must always be adjusted
to the
front
for
locking.
Wall mounting
Up
to model 700 for all ovens metal mounting brackets (see
(except
fig. a)
are available. Mounting bracket is delivered with
model 800) incombustible plate. Dimensions
of
fixing screws and dowels
depend
on
the weight
of
the charge and the quality of
the
wall.
Stacking Where the requirement
is
for two ovens
of
the same size
to
version
be
placed one
on
top of the other, the oven with the least
(not with working temperature should
be
placed
at the
bottom
model 800) (fig. b).
Remove the front feet
of
the top oven and replace them with
the ones supplied with the stacking device (only
if the
ovens
are
not originally supplied with the stacking
de-
vice.) Remove the top of the bottom oven and turning
it
upside down place the drilling jig into the back corner.
Mark
out the
hole position and drill
a
4,2
mm
diameter
hole.
With the screws provided fix the centering cylinders
into position and re-fix top cover.
Model 700 can only be stacked with
an
intermediate frame.
Warning! Before retroving top cover
-
pull out plug!
Attention! Take special care when working at high tempera-
ture.
Outside case temperature may be high.
Attention!
Extremely strong shocks during transport can cause
a
displacement
of
the
temperature sensors in the holding clips inside the working space.
Take care before the first putting into operation that
the
temperature
sensors
are
checked on their correct position and
if
necessary slided
cautiously into the holding clip resp. pulled out
of
the holding clip (see
drawing).
ceiling of
working space
back panel of ^^
working space S