Operating instructions

UP/BP/ULP/SLP 400 - 800
47
R
Readjusting the door ........................................40
real-time clock...................................................20
RS232/RS485 converter...................................17
RS232C interface ...............................................5
Rust deposits ....................................................41
S
Safety devices ..................................................33
Segment end command ...................................26
Segment end commands..................................25
Segmentabschlußbefehle.................................15
self-diagnostic system ........................................5
Serial communication interface ........................16
serial interface ..................................................13
set button..........................................................27
setpoint-dependent operation...........................30
Setting temperature range..................................6
SETUP........................................................16, 20
shelves..............................................................35
slot for MEMory Card........................................10
software...........................................................32
SP.WT ..................................................25, 38, 39
Stacking device...................................................8
sterilisation........................................................36
sterilisation profile.............................................38
sterilisation time ................................................36
sterilising cassettes ..........................................37
Storage volume for protocol data .................12
subframe .............................................................8
Submenu...........................................................11
Submenu SETUP..............................................20
T
TB .................................................................6, 34
temp ...................................................................4
TEMP ..........................................................15, 19
Temperature limiter...........................................34
temperature profile............................................27
TIME .................................................................15
Transport ...........................................................4
TWB .............................................................6, 33
TWW ............................................................6, 33
V
VIEW.................................................................24
W
Wall fixing, hole pitches for for wall fixing ...........8
Wall mounting .....................................................8
Working controller module..........................11, 18
Working temperature range................................6
Write protection ..............................................12
write/read device...........................................5, 13
Glossary:
 nominal temperature = the maximum adjustable setpoint temperature of the oven.
 ambient temperature = the continuous temperature of the room in which the oven is
set up.
 set point-dependent operation = the integrated digital timer for the gold time does not
start until temperature in the chamber has reached the setpoint to within at least 0,5 ºC
at 70 ºC nominal temperature or 2 ºC at 220/300ºC nominal temperature.
 steady-state condition = the selected setpoint temperature has been reached and
remains stable, i.e. the actual temperature has remained unchanged for at least 5
minutes.