Manual

34
D24034 | Date 10/2014
Menu mode
7.3.2
Unit
Here, you can choose whether the temperature is displayed in
°
C or °F.
7.3.3
Timer mode
Here, you can choose choose whether the digital backwards
counter with target time setting (see page 25) should run
setpoint-dependent or not. This determines whether the timer
should not start until a tolerance band of ±3 K around the set
temperature is reached (Fig. 19, B) or if it should start right after
activation (A).
t
Timer
t
Timer
A
B
°C/°F
t
6 K
Fig. 19
Timer mode
A Timer independent of setpoint: Timer starts right after activation
Fig. 19
A Timer independent of setpoint: Timer starts right after activation
Fig. 19
B Timer setpoint-dependent: Timer does not start until tolerance band is reached
A Timer independent of setpoint: Timer starts right after activation
B Timer setpoint-dependent: Timer does not start until tolerance band is reached
A Timer independent of setpoint: Timer starts right after activation
7.3.4
Type of the
slide-in unit (
Grid or
Shelf)
Here, you have to set the type of the slide-in unit (grid or shelf)
used. The selection Shelf enables you to adjust the control
function to the different air flow characteristics in the interior
when using optional sliding shelves instead of the grids that are
part of the standard delivery.
7.3.5
Temperature monitoring
Here, you can set the trigger temperature of the automatic
temperature monitoring system (
Max Alarm, description from
page 27).
The monitoring temperature must be set sufficiently high
above the maximum set temperature. We recommend
1 to 3 K.
SETUP
Unit
IP address 255.145.136.225
Subnet mask 255.255.0.0
Alarm temp
°C °F
TWW TWB
Timer mode
Slide-in unit
Grid Shelf
SETUP
Unit
IP address 255.145.136.225
Subnet mask 255.255.0.0
Alarm temp
°C F
TWW TWB
Timer mode
Slide-in unit
Grid Shelf
SETUP
Unit
IP adress 255.145.136. 225
Subnet mask 255.255.0.0
°C °F
Timer mode
Alarm temp
TWW TWB
Slide-in unit
Grid Shelf
SETUP
Max Alarm
37 °C
2/2