Instruction Manual

42
CELSIUS 10 FDA-Edition
8.1.7
Saving and loading tempering profiles
In order to prevent any alteration of files, CELSIUS FDA encrypts all profile and protocol
files. Encryption employs a key which is specified in the
licence file. Existing files from a
previous CELSIUS version can not be read or exported. If an encrypted file has been altered
(except through CELSIUS), access to the data is no longer possible, even for the producer
of the software.
A tempering protocol can be saved
►
To File (
or
or
"File"
→
"
Save Tempering Profile"
→
"To File"). In the window that
opens, you
can specify the file name and the
storage location. In the preset directory
there is a folder
each for tempering profiles and for protocols.
With "File"
→
"Load Tempering Profile"
→
"From File" or
you can open saved tempering
you can open saved tempering
profile files (*.cel) and edit them.
►
In the oven (
or
or
"File"
→
"
Save Tempering Profile"
→
"To Device"). The tempering pro-
file is saved in the
file is saved in the
ring protocol memory of the
ov
en. It can be opened and edited with
"File"
→
"Load Tempering Profile"
→
"From Device".
►
To Internal MemoryCard
(
or
or
"File"
→
"Save Tempering
Profile"
→
"To Internal MemoryCard
"To Internal MemoryCard
"). With this command,
the tempering profile on the MEMoryCard can be stored
in the
controller of the oven. In this case, the
MEMoryCard must be compatible with the
oven model.
You may enter a name for the tempering profile saved on
the card (max. 8 characters, no spaces) or use the name
suggested.
If you enable "Write Protection", you ensure that the tempering profile on the MEMoryCard
cannot be altered by the
controller of the oven. This write protection has no effect on
CELSIUS writing data to the MEMoryCard. The default setting for write protection is ON.
Only one tempering profile can be written on a
MEMoryCard XL. The MEMoryCard XL can
be
overwritten at any time, however.
►
To External MemoryCard
("File"
→
"
Save Tempering Profile"
→
"To External MemoryCard (
USB/
RS 232)". This allows you to save a tempering profile of up to 40 ramps on a card in a con-
nected and logged on card reader (see page
45
).
With "File"
→
"Load Tempering Profile"
→
"From Internal MemoryCard
"/"... external" you can open
tempering profiles stored internally
or externally on the MEMoryCard.