Manual

8 D24042 | Date 09/2014
AtmoCONTROL
3.2
Programme interface
The
main programme interface window of AtmoCONTROL is divided into the following areas:
1
2
3
4
6
5
1
Menu bar (see section 3.2.1)
2
Toolbar (quick access to most important functions, see section 3.2.2)
3
Status bar (provides an overview of available appliances, see page 10)
Toolbar (quick access to most important functions, see section 3.2.2)
Status bar (provides an overview of available appliances, see page 10)
Toolbar (quick access to most important functions, see section 3.2.2)
4
Show/hide status bar
Status bar (provides an overview of available appliances, see page 10)
Show/hide status bar
Status bar (provides an overview of available appliances, see page 10)
5
Editor, simulation and protocol window (only for appliances listed on page 6,
otherwise only protocol window)
Editor, simulation and protocol window (only for appliances listed on page 6,
otherwise only protocol window)
Editor, simulation and protocol window (only for appliances listed on page 6,
6
Programming mode switch (for editor/simulation/protocol, see pages 22 and 28)
otherwise only protocol window)
Programming mode switch (for editor/simulation/protocol, see pages 22 and 28)
otherwise only protocol window)
(only for appliances listed on page 6)
Programming mode switch (for editor/simulation/protocol, see pages 22 and 28)
(only for appliances listed on page 6)
Programming mode switch (for editor/simulation/protocol, see pages 22 and 28)
You may change the
language of the
programme interface at any time. Ger-
man or English can be set („Options"

„Language”).