User Manual
16
D30396 | Date 09/2014
AtmoCONTROL FDA Version
5.
Programme
5.1
Editor window
5.1.1
Overview
In the Editor window, programmes can be created: sequences of various parameters (e.g.
temperature, pressure and humidity), which the appliance then implements from a definable
point in time.
To be able to create a programme in AtmoCONTROL, the appliance which is to perform the
programme must be listed in the status bar and selected (clicked on). The appliance can, but
does not have to, be connected to the computer via the network. If the appliance is not yet
listed in the status bar, it must be added (see page 13).
5.1.2
Creating a programme
Select the appliance that will later perform the programme by clicking on it in the status
bar (Fig. 2, No. 1). An icon bar with the available parameters (functions) for this appliance is
shown (2, description from page 18). Additionally, one or two
editor threads (3 and 4) are
displayed, depending on the appliance. The programme sequence is determined on these.
Two editor threads are always shown for appliances with humidity or pressure control,
and one editor thread for all others.
Bear in mind that the two editor threads are not synchronised. This means that a specific X
position on one thread does not match the same position on the other thread in time. If you
want to see the parameter values for a specific point in time, you must change to the simula-
tion mode (see page 24).
If you want to create a time correlation to a specific point, use the "
Sync" function (see page
22).
1
2
3
4
Fig. 2
Elements to create a programme
1
Appliance selected
Fig. 2
Appliance selected
Fig. 2
Elements to create a programme
Appliance selected
Elements to create a programme
2
Available parameters (functions)
Appliance selected
Available parameters (functions)
Appliance selected
3
Editor thread
Available parameters (functions)
Editor thread
Available parameters (functions)
4
Additional editor thread for appliances with humidity or pressure control