User guide

C6010 Setting up your C6010 printer
5 December 2012 – v1.0
Page 26 of 100
10. Remove the printhead cartridge from the foil bag.
11. Remove the orange protective plastic cover from the printhead cartridge. Holding the
printhead cartridge by the handle:
 Release the flaps covering the ink ports (1 and 2).
 Release the clip retaining the cover near the center of the printhead cartridge (3).
 Carefully remove the protective cover (4).
12. Remove the protective strip from the electrical contacts.
While holding the printhead cartridge by the handle with one hand, grasp the pull tab with
the other hand and, slowly and carefully, peel back the plastic strip covering the electrical
contacts.
Dispose of the removed strip immediately and do not allow the removed strip to contact the
electrical contacts.
13. Remove the protective strip from the printhead nozzles.
While holding the printhead cartridge by the handle with one hand, grasp the pull tab with
the other hand and slowly and carefully peel back the plastic strip covering the printhead
nozzles. Maintain an angle of no less than 45° with the printhead surface when pulling on
the strip.