User guide
C6010 Setting up your C6010 printer
5 December 2012 – v1.0
Page 24 of 100
Using intermediate paper sizes
Tray 1 should be loaded only with ISO A4, US Letter or US Legal paper sizes and is designed
to take paper from 70 gsm (19 lb) to 120 gsm (32 lb) weight. However paper properties can
vary widely between manufacturers, so if the heavier weight paper you have chosen does not
feed well from Tray 1, use Tray 2 instead.
Intermediate size paper up to US Legal size that cannot be loaded in Tray 1 should be printed
via Tray 2. See Using Tray 2 on page 53 for instructions.
Installing the printhead cartridge
Your C6010 printhead cartridge is a delicate micro-electrical-mechanical device and should
be treated with due care to avoid degradation of print quality.
DO NOT touch the printhead cartridge ink couplings, nozzle surface or the electrical contacts
when installing the printhead cartridge. Hold the printhead cartridge ONLY by the handles. See
Printhead cartridge on page 13 for the location of these features.
Do not place the unprotected printhead cartridge on any surface prior to installation in the
printer. Protect the printhead cartridge at all times from contamination by air-borne
contaminants, such as dust or fibres.
DO NOT unpack the printhead cartridge until the printer has been prepared for installation. Delay
in installation of the printhead after unpacking can compromise print quality due to dehydration.
1. Ensure your printer is switched on and the power lamp is lit and steady.
2. Open the printhead cover to reveal the printhead latch (see Internal view on page 12).
3. Follow the message shown on the LCD screen to choose your language.
4. When the Press to install print head message appears on the LCD screen, press the
OK/Resume button to proceed.
5. This will automatically initiate printhead latch opening. The power lamp will bink when
latch opening is under way. This process may take several seconds.
If the printhead latch cannot be released automatically as described, contact support personnel.
DO NOT attempt to release the printhead latch in any other manner by yourself.