User's Instructions

Le présent appareil est conforme aux CNR d'Industrie Canada applicables
aux appareils radio exempts de licence. L'exploitation est autorisée aux deux
conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2)
l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi,
même si le brouillage est susceptible d'en compromettre le fonctionnement
The device meets the exemption from the routine evaluation limits in section
2.5 of RSS 102 and compliance with RSS-102 RF exposure, users can
obtain Canadian information on RF exposure and compliance.
Le dispositif rencontre l'exemption des limites courantes d'évaluation dans
la section 2.5 de RSS 102 et la conformité à l'exposition de RSS-102 rf,
utilisateurs peut obtenir l'information canadienne sur l'exposition et la
conformité de rf
3
Moisture Sensor Spec:
■
Model: 95339
■
Range:
30 m (100 ft) without interference
■
Temperature Operating:
32 - 110° F (0 - 45° C) T45
■
Operating Frequency:
915 MHz (N. Amer.)
■
Max Power:
< 10 dbm
■
FCC ID:
VAF-93S1
■
IC:
7111A-93S1
■
Power:
3V DC 2 x AA LR6 / 1.5V
For outdoor use with cold water only!
Not for use with household appliances
Do not mix Alkaline, carbon-zinc, or rechargeable
batteries Used or dead batteries must be removed
from the timer and disposed properly
4
FCC Statement:
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions:
(1) This device may not cause harmful interference,and (2) this device must
accept any interference received, including interference that may cause
undesired operation.
Caution: Any changes or modifications not expressly approved by our Yuan
Mei Corp. could void the user's authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
■
Reorient or relocate the receiving antenna.
■
Increase the separation between the equipment and receiver.
■
Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
■
Consult the dealer or an experienced radio/TV technician for help.
To comply with FCC RF exposure requirements, the device and the antenna
for this device must be installed to ensure a minimum separation of 20cm or
more from a person’s body. Other operating configurations should be
avoided.
5
CAN ICES-3 (B)/NMB-3(B) Canada Statement
This device complies with Industry Canada’s licence-exempt RSSs.
Operation is subject to the following two conditions:
(1) This device may not cause interference; and (2) This device must accept
any interference, including interference that may cause undesired operation
of the device.
Melnor, Inc.
109 Tyson Drive
Winchester, VA 22603, USA