user manual
refrigerated cold water.
WARNING: fill with fresh clean water only.
CONNECTING YOUR ICE MAKER:
*If the plug, power cord or appliance is damaged
in any way, please return the unit to the
manufacturer or their designated service agents
to avoid the risk of electric shock or injury.
1. This unit should only be used in a single
standard wall socket. Ensure that the plug fits
securely and correctly into the wall socket. Do
not try to alter or change the plug as this could
be dangerous and will render the warranty null
& void.
2. This appliance requires a wall socket that is
capable of a supply of 220-240V, 50Hz.
CLEANING & MAINTAINING YOUR ICE MAKER:
Before using your ice maker, clean the appliance
thoroughly as explained in “OPERATING
PROCEDURES & MAINTENANCE”.
1. Take out the ice basket.
2. Clean the removable ice basket & ice shovel
with diluted detergent, warm water and a soft
cloth. Then rinse with clean warm water.
3. Use clean water to rinse the inside parts, and
drain out the water by removing the water drain
cap on the right front bottom corner of the base.
Ensure to pour the water out into a sink/basin
and dispose of the water correctly.
4. The outside of the ice maker should be cleaned
regularly with a mild detergent solution and
warm damp cloth. Rinse with a clean damp
cloth.
5. Clean the water tank with water and a mild
detergent using a soft damp cloth, then
rinse with a clean soft damp cloth.
6. Dry the interior and exterior with a clean soft cloth.
7. When the product is no longer required for
regular use, drain all water & dry the interior.
USING YOUR ICE MAKER:
1. Clean the unit following the instructions under
the “Cleaning and maintaining your ice maker”
section of this instruction manual. Open the
cover, remove the ice basket and pour water
into the tank. Keep water level below the
“MAX” water level mark.
2. Press the “ON/OFF” button on the control
panel to begin the ice making cycle.
3. Select the ice cube size by pressing the
“SELECT” button. If the room temperature is
lower than 15 C, it is recommended that the
small ice cube setting is selected in order to
avoid ice bullets sticking together.
4. The ice making cycles last approximately 6
to 13 minutes, depending on selection of ice
cube size and the room temperature. The room
temperature should be between 10 C to 35 C
when making ice.
5. If the water pump can’t supply water to the
ice making box, the ice maker will stop
automatically, and the “Add Water” indicator
will illuminate. Press the “ON/OFF” button
to switch the unit off then fill water up to the
maximum water level mark and press “ON/OFF”
button again to switch the unit on.
6. The unit stops when the ice basket is full and
the “Ice Full” indicator is illuminated. Remove
the ice bullets and replace the empty ice
basket to continue making ice.
WARNING: Direct sunlight or sunlight reflection
may cause the infrared sensor to malfunction.
If the unit doesn’t stop when the ice cubes
obstruct sensor, please contact the customer care
department and seek advice.
7. Change the water in the water reservoir every
24 hours to ensure a safe hygiene level.
MW_ICM001A_IM.indd 4 31/08/2011 08:29:20