user manual

PREPARING YOUR ICE MAKER FOR USE
When using electrical appliances, basic safety
precautions should be followed to reduce the risk
of fire, electric shock, and injury to persons or
property. Read all instructions before using any
appliance.
SAFETY ADVICE:
- Do not operate this appliance with a damaged
power cord. If the power cord is damaged,
it must be replaced by the manufacturer or its
service agent or a similarly qualified person in
order to avoid a hazard.
- Ensure that the voltage on the rating label
corresponds with the voltage of the wall socket.
No other appliance should be plugged into
the same wall socket when using this appliance.
Ensure that the plug is fully inserted into the wall.
- Do not allow the power cord to come into contact
with hot, rough or sharp surfaces and objects.
- Do not allow the power cord to hang over the
edge of the counter.
- Do not use this appliance with plug adaptors
and extension cords.
- Switch off the appliance & remove the plug from
the wall socket before undertaking any cleaning
task or when the appliance is not in use.
- This appliance is intended for household use
only. Do not use the appliance outdoors.
- Do not place this product in direct sunlight.
- Ensure that there is a 10cm gap between the
unit and surrounding objects.
- Do not use any other liquids to make ice-cubes
other than clean water.
- Do not clean your ice maker with flammable
or hazardous fluids. The fumes can create a fire
hazard or an explosion and could be hazardous
to your health.
- Do not tilt or turn the appliance over. This
appliance should remain upright at all times.
- This appliance is not intended for use by
persons (including children) with reduced
physical, sensory or mental capabilities, or lack
of experience and knowledge, unless they have
been given supervision or instruction concerning
use of the appliance and are supervised during
use of the appliance by a person responsible
for their safety.
- Children should be supervised to ensure that
they do not play with the appliance.
- Use the appliance in a well ventilated area.
- Do not place the appliance on hot surfaces,
such as cooking plates, gas burners, ovens
or similar.
CAUTION: In order to prevent overheating do not
cover the appliance.
- Do not use the appliance if it has fallen on the
floor, if there are visible signs of damage or if it
has a leak.
- Do not pull on the power cord to remove the
plug from the wall socket. Do not use the power
cord to lift, pull or carry the appliance.
- Always use the appliance on an even surface.
- Do not touch the plug, power cord or appliance
with wet hands.
- Do not submerge the plug, power cord or
appliance in water or any other liquid.
- Only use this appliance for its intended purpose.
- Only use the accessories provided with this
appliance. Using other accessories can cause
the appliance to malfunction.
- Do not touch the evaporator while the appliance
is in use.
OPERATING PROCEDURES & MAINTENANCE
UNPACKING YOUR ICE MAKER:
1. Remove the exterior and interior packaging.
Check if ice basket and ice scoop are inside.
If any parts are missing, please contact our
customer service department.
2. Remove the tape securing the ice shovel, ice
basket & ice scoop in place. Clean the tank &
ice basket.
3. Put the ice maker on a level counter top away
from direct sunlight or any other sources of heat.
4. Ensure that the unit has a 10cm space on all
sides from surrounding objects.
5. Allow the water to circulate through the
product until it indicates “ADD WATER”.
6. Empty all water and refill the product with fresh
clean water.
7. Only use cold water when using this product.
8. To get larger, more dense ice bullets, use
MW_ICM001A_IM.indd 3 31/08/2011 08:29:20