Technical data

30
Figure 16 Power Supplies in the E2600 Controller-Drive Tray
1. Power-Fan Canister for Controller A
2. Power-Fan Canister for Controller B
8. Disconnect the following cables from both controller canisters.
— Host interface cables
— Drive interface cables
— Ethernet cables
If fiber-optic cables are present, you can lift the two release levers and partially
remove the controller canister. Opening these release levers makes it easier to
press down on the fiber-optic cable release tab.
9. Remove both controller canisters from the controller-drive tray as shown in the
following figure.
a. Unlock and pull out the release levers to release the controller canisters.
b. Using the release levers and your hands, pull both controller canisters out of
the controller-drive tray.
c. Set each controller canister on a flat, static-free surface near the
controller-drive tray. Position the controller canister so that you can access
the top cover.
NOTE The following figure shows controller A being removed. You remove
controller B in the same way.