User`s manual

ConnectX-2 VPI InfiniBand and Ethernet Adapter Card User’s Manual Rev 1.0

Mellanox Technologies

3. During Lightning - Electrical Hazard

4. Copper InfiniBand Cable Connecting/Disconnecting

5. Equipment Installation

6. Equipment Disposal

7. Local and National Electrical Codes

8. Exposure to Radiation

2.4 Cables and Modules

This card can be connected using direct copper cables or optical cables using an SFP+ transceiver

module. Copper cables can be both active and passive.

During periods of lightning activity, do not work on the equipment or connect

or disconnect cables.

Copper InfiniBand cables are heavy and not flexible, as such they should be

carefully attached to or detached from the connectors. Refer to the cable manu-

facturer for special warnings and instructions.

This equipment should be installed, replaced, or serviced only by trained and

qualified personnel.

Disposal of this equipment should be in accordance to all national laws and

regulations.

This equipment should be installed in compliance with local and national elec-

trical codes.

Caution – Use of controls or adjustment or performance of procedures other

than those specified herein may result in hazardous radiation exposure.

CLASS 1 LASER PRODUCT and reference to the most recent laser standards

IEC 60 825-1:1993 + A1:1997 + A2:2001 and EN 60825-1:1994+A1:1996+

A2:2001