Operation Manual

64
11.3 Cleaning the brewing unit
Prerequisite: The appliance is in stand-by mode (see „Switching on and off“
on page 51).
Note
For optimal protection of your appliance, we recommend that you clean the
brewing unit under running tap water once a week.
• Switch the power switch (Fig. B, No. 20) to position „0“ to turn off the
appliance completely.
• Reach into the recess on the right side of the appliance (Fig. B, no. 18)
and pull off the cover to the right.
• Press and hold the red button on the handle of the brewing unit (Fig. H)
and turn the handle clockwise to the stop (by about 75°).
• Use the handle to pull the brewing unit out of the appliance.
• Leave the brewing unit as it is (do not move or twist the components of
the brewing unit).
• Thoroughly rinse off the entire brewing unit from all sides under running
water. Particularly ensure that the surface shown in Fig. J is free of
coffee residues.
Caution!
Never clean the brewing unit in the dishwasher.
• Let the brewing unit drip dry.
• If necessary, remove coffee residues from the surfaces in the interior of
the appliance where the brewing unit is inserted.
• Reinsert the brewing unit into the appliance and turn the handle of the
brewing unit anti-clockwise to the stop to lock.
• Insert the two catches of the cover into the back of the appliance and
swing the cover to the left until it locks into place.
• Switch the power switch (Fig. B, No. 20) to position „I“.
• The appliance goes back to stand-by mode.