User guide

20
• Cutting hair: Start with sides or neck. Work
towards centre of head. Trim fringe by
moving trimmer from forehead towards
centre of head. Brush the hair cuttings away
from the head as you go to see how you
progress. Use a progressively shorter cutting
length until hair has the desired length.
• The cutting head will slow down or become
blocked if the trimmer is moved too fast or if
you cut too much hair at a time.
• Regularly shake hair cuttings from the
appliance to prevent the cutting head from
becoming blocked.
Battery charging
1. Set connector in the power connection
underneath the appliance or if the appliance
is in the base, set connector in the power
connection (2) on the side of the base (1)
2. Plug in to mains.
3. Check appliance is switched off (set on/off
button to 0) to ensure charging.
o Red LED (4) will be lit during recharging.
o The indicator does not switch off when
charging is complete but the appliance
switches off automatically, as it is
protected against excess charging.
o Battery will begin to charge when
appliance is returned to base and base is
connected to mains. To avoid charging,
disconnect adapter from mains.
o When battery is fully charged, the trimmer
can operate for approx. 45 minutes.
NOTE! For maximum operating time, only
recharge when performance becomes
noticeably reduced.
Cleaning and Maintenance
• Switch off the appliance and disconnect
from the mains before cleaning.
• Brush cutting head and comb attachments
using the small cleaning brush (12) after
each use.
• Remove cutting head if necessary:
o Grip cutting head front edge, pull
backwards.
o Brush recess under cutting head.
o Replace cutting head by inserting black
tongue on back of head into hole in
appliance, and push until you hear a
click.
• Lubricate as required: Apply 1-2 drops of the
supplied lubrication oil on cutter and run for
approx. 10 seconds to evenly distribute oil.
Wipe off any excess oil with a cloth.
• Never submerge the appliance in water and
make sure no water enters the appliance.
• Clean the appliance by wiping it with a damp
cloth. Do not use detergents of any kind.
• Do not use scouring pads, steel wool or
any form of strong solvents or abrasive
cleaning agents to clean the appliance, as
they may damage the external surfaces of
the appliance.
• IMPORTANT! Allow to dry completely after
cleaning. Do not use the appliance if it is
damp.
Caution! Only use acid-free oil, e.g. sewing
machine oil, if the supplied oil runs out.
Removing the battery before disposal
Before discarding the trimmer, the rechargeable
battery must be detached.
1. Disconnect the trimmer from the mains if
connected.
2. Run trimmer until battery is completely
discharged.
3. Remove cutting head.
4. Unscrew the two screws in recess below
cutting head and the single screw on the
rear trimmer and separate the two halves,
using a flat-headed screwdriver if necessary.
5. Remove the battery from the print plate
using a pair of plyers and dispose of the
parts in compliance with local regulations
(see below).
6. Never connect appliance to mains after
battery has been removed.