User guide

19
KEY TO THE MAIN COMPONENTS OF THE
APPLIANCE
1. Base with charger
2. Base power connection (not visible in
picture)
3. Trimmer power connection (underneath)
4. Recharging indicator
5. Beard and hair trimmer
6. ON/OFF button
7. Hair-length setting (not visible on picture)
8. Spacer comb
9. Removable cutting head (below spacer
comb)
10. Spacer comb lock button (on rear of
appliance)
11. Adapter with cord
12. Cleaning brush
13. Comb
14. Scissors
15. Connector
Lubricating oil included
USING THE BEARD AND HAIR TRIMMER
Before using for first time
Before using the beard and hair trimmer (5)
for the first time, fully charge the battery (See
Battery Charging below), which takes approx. 8
hours (first time approx. 24 hours). Lubricate the
cutting head (9) with 1-2 drops of the supplied
lubricating oil.
Use
The appliance can be used with or without a
spacer comb, depending on the hair length
required (see table below).
1. Fit the spacer comb (8) via the grooves
on the appliance sides and press firmly
into place until it clicks. The arrow on the
appliance must be aligned with "1" on the
hair-length setting (7) on the spacer comb
2. Set desired hair length by sliding spacer
comb up or down.
o The spacer comb has seven hair-length
settings: 1 = 4 mm, 2 = 7 mm, 3 = 10
mm, 4 = 13 mm, 5 = 16 mm, 6 = 19 mm
and 7 = 22mm.
o The cutting head may be used without a
comb for making clean edges along the
edges of the beard, e.g. in the case of
sideburns.
3. Lock spacer comb securely in the selected
position by pressing the spacer comb lock
button (10) up (to "LOCK" position) on the
rear of the appliance.
o To remove the spacer comb, push the
spacer comb lock button down to the
"UNLOCK” position. Remove the spacer
comb.
4. Switch on the appliance using the on/off
button (6) and commence trimming.
The appliance can be used powered directly via
mains if battery not charged.
1. Attach the connector (15) to the trimmer
power connection (3) underneath the
appliance.
2. Place adapter (11) in mains socket.
3. Proceed as described above.
NOTE! If the appliance does not work when
connected to mains and battery is flat, switch
off and recharge for 5 minutes. It will then work
powered via the mains.
Tips
• Check the required spacer comb is fitted
correctly and set to required length.
• Hold trimmer with sloped side of spacer
comb to head/face, and move in slow, even
movements through hair/beard. For best
result move against the growth direction of
the beard. If necessary, use the scissors (14)
and the comb (13).
1.
2.
3.
4.
5.
6.
8.
7.
9.
10.
11.
12.
13.
14.
15.