Specifications

X Beam Assembly
The X beam assembly consist of the X carriage, X motor, X drive belt, and various
other mechanical components that make up the device that holds the hoop during
the embroidery process. The X beam is attached to the Y drive system by
connecting to the Y drive rails at either end of the beam. Refer to Figure 2-14 to
identify various areas of the X beam assembly.
X Motor
The X motor is attached to back side of the right end of the X beam and has a
direct pulley to the X drive belt. Refer to the following procedure to replace the X
motor and adjust the X drive belt tension.
Motor Replacement
NOTE: This procedure requires a specific Melco force gauge (p/n 995585-01) for
proper belt adjustment after replacing the motor.
1. Turn OFF the power switch to the EMT 10T and remove the power cord from the
power source electrical outlet and the rear of the machine.
drive belt
tensioning
screw
X beam
tensioner
block
mounting
screws
X drive belt
motor
pulley
motor screws
(4 each)
X motor
X harness
interface PCB
see detail
of this
area in
Figure 2-15
X harness
interface PCB
cover screws
(3 each)
cover
X carriage removed to
show X beam detail
Velcro lint wiper
located under
tensioner block
Figure 2 - 14
X Motor 2 - 17
110291-01, Rev D 2. Service Maintenance (except head and trimmer)