Specifications

Color Change Cam Assembly Replacement
If replacing the color change cam and associated hardware, refer to the following
procedure to allow the new assembly to rotate freely within the bracket.
1. Remove the tensioner bracket covers and the color change covers as described
earlier.
2. Remove the color change PCB as described earlier.
3. Remove the color change motor as described earlier.
4. Refer to Figure 3-23 to remove the 2 screws, then the color change bracket (with
cam and hardware).
5. Refer to Figure 3-24 and disassemble the various parts of the color change cam
assembly to replace the part in question. Leave the pulley and spacer attached
to the left side of the shaft if possible.
6. Refer to Figure 3-24 to reassemble the color change cam assembly parts loosely.
7. Install the color change PCB to put the color change bracket to the form it will
take when completely assembled.
8. Tighten the color change cam onto the shaft flats.
color change
bracket (with motor,
PCB, and cam)
2 color change
bracket screws
color change
mount key
Figure 3 - 23
Color Change Cam Assembly Replacement 3 - 25
110279-01, Rev B 3. Embroidery Head Maintenance