Specifications

8. Replace with new solenoid by reversing the procedure above. Adjust the position
of the solenoid into the solenoid bracket using the "thread counts" or
measurement you obtained above (see previous NOTICE).
9. Position the jump stitch bracket back in the embroidery head against the
mechanical stop.
10. Insert a 5 mm hex wrench in the cap head set screw at the right end of the Z
shaft and rotate clockwise to move the heads through at least one revolution to
check that no mechanical interference occurs.
NOTE: During installation the solenoid must be adjusted properly. If you did not
adhere to the previous NOTICE, or if for some other reason, the
adjustment for the solenoid is not correct, Refer to the following jump
stitch solenoid adjustment procedure for the proper adjustments.
Jump Stitch
Solenoid locking
nut
2 solenoid
bracket screws
record solenoid
threads here
Mechanical Jump
Stitch mechanism
and cover
Jump Stitch
Solenoid and
Bracket
SHOWN WITH NEEDLE
CASE AND OTHER
PARTS REMOVED FOR
CLARITY ONLY
cover
screws
Figure 3 - 17
3 - 18 Jump Stitch Solenoid
EMT 10/4T Technical Manual Melco Embroidery Systems