Specifications

3. Disconnect the Z motor harnesses from the associated in-line XYZ driver harness
connections.
4. Remove the four socket head cap screws attaching the motor to the motor
support bracket (see Figure 3-3).
5. Tilt the motor slightly to allow the drive belt to slip off the motor drive pulley and
remove the motor from the support bracket.
6. Loosen the pulley set screws and remove the pulley from the motor shaft.
Z motor
drive area
cover
c)Remove the 2 screws located
at the base of the outer (left)
surface of the cover.
c)Remove the only screw at
the front surface of the cover
b)Of the 3 screws located
near the head and directly
below the 2 screws removed
in step a, remove the 2 outer
screws. Leave the middle
screw secure.
a)Remove the 2 screws on
the inside surface of the
cover near the head, just
above the Z drive shaft.
FRONT VIEW
head #4
Figure 3 - 2
socket head
cap screws
(4 places)
Z Drive
Motor
Motor
Bracket
Z Drive Belt
Figure 3 - 3
Z Motor Replacement 3 - 3
110279-01, Rev B 3. Embroidery Head Maintenance