Specifications

Power and Light Switch Removal/Replacement
1. Refer to Figure 2-24 and unplug the main power cord at the entry module on the
AC voltage distribution panel inside the left frame leg.
2. Remove 4 screws fastening the power tray cover and remove the cover.
3. Remove 4 screws fastening the AC voltage distribution panel (see Figure 2-26),
and lower the module to the bottom of the frame leg.
4. Pull off 4 spade terminals from the switch being replaced.
5. Squeeze the tabs on top and bottom of switch and push the switch out from the
inside of the frame leg.
6. Replacement is the reverse of removal.
AC VOLTAGE DISTRIBUTION PANEL
4 each panel
fastening screws
Figure 2 - 26
2 - 34 Power Distribution Section
EMT 10/4T Technical Manual Melco Embroidery Systems