Specifications

Logic Power Supply Removal/Replacement
1. Remove the power supply assembly from the left frame leg as described earlier.
2. Refer to Figure 2-23 to identify the location of the logic power supply and estop
PCB. Unplug the 2 power connectors (labeled P8 & P9) from the estop PCB.
3. Unplug the 4 spade terminals (wires colored blue, brown, black & white) from
the estop PCB.
4. Remove the 3 mounting screws from around the fan on the outside of the power
supply assembly, and remove the Logic supply.
5. Replacement is the reverse of removal.
24V Power Supply Removal/Replacement
1. Remove the power supply assembly from the left frame leg as described earlier.
2. Refer to Figure 2-23 to identify the location of the 24V supply and remove the 3
ring terminals from the connector labeled J1 and the 4 fork terminals from the
connector labeled J2.
3. Remove the 4 mounting screws from the outside of the power supply assembly
and remove the 24V supply.
4. Replacement is the reverse of removal.
POWER SUPPLY ASSEMBLY
4 screws fastening the
power supply assembly from
the outside of the peripheral
frame leg (see Step 4)
4 screws securing the power supply
assembly to the under side of the frame
from the inside the leg (see Step 5)
Figure 2 - 24
2 - 32 Power Distribution Section
EMT 10/4T Technical Manual Melco Embroidery Systems