Specifications

Electronics Section
The electronic section consists of the major electronic printed circuit boards located
within an RFI controlling box called the card cage. The card cage is located inside
the right chassis leg (see Figure 2-13).
Remove Card Cage Cover
1. Turn OFF the power switch to the EMT 10/4T.
2. To remove the card cage cover, remove the screws and associated hardware
from around the cover as shown in Figure 2-18 and lift the cover off.
Caution: When the electronics cover is removed the various printed
circuit boards are exposed. DO NOT TOUCH THESE BOARDS Without
Using Antistatic Precautions as instructed in this manual.
IMPORTANT: Do Not operate the embroidery peripheral with the
electronics cover removed. This cover provides the top of the EMI
shielding for reducing RF interference. Operating the equipment
without the shield (cover) can be a violation of FCC regulations.
Card Cage
Cover
Card
Cage
screws
VIEWED FROM REAR
OF PERIPHERAL
Figure 2 - 18
2 - 24 Electronics Section
EMT 10/4T Technical Manual Melco Embroidery Systems