Specifications

3. There are two harnesses leading from the motor and one harness connected to

the motor encoder. Disconnect the motor encoder harness connection.

4. Remove the cover from the harness way located on the inside front wall of the

frame top support platform to access the in-line connections for the two motor

harnesses.

5. Disconnect the two motor in-line harness connection and remove them from the

harness way.

6. Loosen the four socket head cap screws holding the Y motor to the motor

bracket (see Figure 2-14).

7. Tilt the motor slightly to allow the motor belt to slip off the motor drive pulley.

NOTE: The motor shaft pulley is permanently attached to the motor shaft. Therefore,

the new motor assembly must have a pulley already attached to the shaft.

8. Remove the four socket head cap screws (that are already loosened) and the

associated hardware attaching the Y motor to the motor bracket. Remove the

motor from the support bracket.

9. With the existing hardware, attach the new motor to the bracket and slip the

motor belt over the motor pulley. Be certain the belt is properly fitted on the Y

shaft pulley and directly above the motor pulley.

motor mounting

socket head cap

screw (4 each)

Y motor

bracket

Y motor/belt

cover

Y motor

drive pulley

Y motor

belt

Y shaft

pulley

Figure 2 - 14

2 - 18 Under Carriage Section

EMT 10/4T Technical Manual Melco Embroidery Systems