Specifications

10. Check the Y drive belt tension on the other three belts the same method as in
the previous steps.
The tensions of the four belts should be within 0.25 pounds of each other.
11. If needed, adjust the other Y drive belts to the proper tension according to the
above specifications.
12. Repeat this procedure until the proper tension adjustments are attained.
13. Replace all covers removed during this procedure. You may then plug the power
cord back into the voltage source and turn ON the peripheral.
Figure 2 - 12
2 - 16 X Beam Assembly
EMT 10/4T Technical Manual Melco Embroidery Systems