Specifications

4. Position a hex wrench onto one of the two cap head screws in the front of the
frame for adjusting the belt tension (see Figure 2-10).
5. Note the location of the wrench handle and rotate the socket head cap screw
approximately 3 revolutions counter clockwise.
6. Move to the other tensioning socket cap head screw associated with tensioning
the belt and rotate that socket head cap screw the same amount as the first.
7. Remove the two screws, lock, and flat washers at the top of the belt clamp
bracket (see Figure 2-11). These screws go through the belt and into the belt
clamp underneath the belt to secure the Y drive belt between the two pieces.
right side
cover
right side Y
belt tension
adjustment
socket head
cap screws
the left side
and middle Y
drive belt
assemblies
are basically
identical to
the right side
assembly
depicted here.
Figure 2 - 10
Y axis
rail
support
belt clamp
bracket
belt clamp
Y axis rail
Y drive belt
Y idler
pulley
Y home
limit flag
Y home
limit PCB
LEFT Y-CARRIAGE
Figure 2 - 11
2 - 14 X Beam Assembly
EMT 10/4T Technical Manual Melco Embroidery Systems